The oil skimmer of Boat Oil Skimmer is of single row straight shaft rotary table group and aluminum welded casing structure. Several turntable groups with flange aluminum alloy turntables are driven by a hydraulic motor. There are two sets of oil scrapers in the rotary table set to scrape the spilled oil adhered to the rotary table into several collecting pipes and then flow into the collecting grooves. The collected oil is pumped out through the pipe at the bottom of the oil sump. The two ends of the aluminum oil sump are welded with trapezoidal left and right aluminum alloy float shells filled with foaming materials. As the float expands outward, the oil skimmer has good stability in water. The hydraulic motor is installed in the float housing at one end. There is a stainless steel pipe to reinforce the casing and act as a handle. There is a flap door on the side of the oil sump for observing its interior. There is also a handle on the side of the oil sump for lifting and tying the oil skimmer. The oil skimmer has been floated in water before leaving the factory, and the balance and underwater depth have been adjusted, which should not be adjusted in general. The counterweights can be installed under the two floater shells for adjustment.
The Marine Oil Skimmer is equipped with two high-pressure hydraulic hoses connecting the hydraulic motor of the oil skimmer and the power station manifold block. There is a steel wire reinforced transparent plastic hose connecting the suction port of the pumping pump and the oil drain port of the oil skimmer, which can observe the internal liquid flow from the outside; The pipe is equipped with a float to float on the water surface without affecting the balance of the oil skimmer; Both ends of the suction pipe are connected to the oil skimmer and the power station with quick change connectors. There is a discharge pipe connected to the discharge outlet of the pump.
The Brush Oil Skimmer consists of a power machine, a pumping pump and a hydraulic station, which are mounted on a four-wheel frame. The power engine of Oil Spill Skimmer is diesel engine. The pumping pump of rotary disc type oil receiver has strong self-priming capacity, allowing a small amount of solid particles to pass through. The pump is directly connected to the power machine. The hydraulic station of Drum Oil Skimmer includes hydraulic pump, oil tank and manifold block, which are connected by hydraulic pipeline. The hydraulic pump is driven by a power machine; The oil tank and manifold block are equipped with oil suction filter (primary filter), air filter, pressure gauge switch, pressure gauge, temperature level gauge, stop valve (for diesel engine startup), overflow valve, speed control valve and oil return filter (fine filter); The manifold block is provided with a hydraulic oil inlet which supplies oil to the hydraulic motor of the oil skimmer, and the oil return filter is provided with a hydraulic oil outlet which is connected with the hydraulic motor of the oil skimmer.
